WADECO
HOMEJAPANESEChineseKorea
WADECO Co., Ltd.
New ProductsProducts InformationCompany ProfileContact Us
Products Information

Product Tracking Sensor

Compact Type MICRO-REFLEX MWS-ST/SR-2WG-R

UNAFFECTED BY HEAT, FLAMES, AIRBORNE PARTICLES OR VAPOR!

General

MWS-ST/SR-2WG-R Micro-Reflex consists of a pair of transmitting and receiving antennas, connected to separate controllers by circular waveguide tubing.

The antennas, which are unaffected by heat, are installed in the high temperature zone, while the controllers are located in normal room temperature areas. The detection signal outputs when the microwave beam is reflected by the slab/strip into the receiving antenna.

This maintenance free model operates perfectly in high vapor areas where optical and infrared based sensors will not. With a high degree of precision (repeatability), Micro-Reflex provides an economical, reliable and hazard free solution for Product Tracking in Continuous Casting and Rolling Mills.

MWS-ST/SR-2WG-R

Features

• Increased operating range

The operating distance is three times that of the conventional model, thus allowing for use of longer waveguide extensions.

• Unaffected by adverse environments

This sensor is unaffected by heat, flames, airborne particles dense vapor or product temperature variation.

• Simple installation

The antennas and controllers come pre-mounted, on separate stands, further simplifying installation.

• Selectable detection mode

Either unreflected beam (UNREFLECTED) or reflected beam (REFLECTED) detection method may be selected.

• No set-to-set interference

Four channels are available, selectable by rotary switch. This permits the use of multiple units in close proximity to each other.

• Power level & sensitivity indicators

The received power level and the sensitivity-set-point are indicated on a bank of 15 LEDs, allowing for easy visual adjustment and maintenance of the sensor.

• Inspection window (optional)

The received power level and the sensitivity-set-point are easily seen, without removing the controller cover.

• Solid state output

Highly reliable solid state output relay minimizes mechanical failure.

• Enclosure rating IP65 equivalent

• Compact, space saving design simplifies installation

Specifications

Type Transmitter Controller : MWS-ST-2WG
Receiver Controller :
      MWS-SR-2WG
      MWS-SR-2WG-RA (Analog output)
Antenna :
     WG-6C (Ceramic cover)
Power supply AC100~120V or AC200~240V ±10%, 50/60Hz
Power consumption Transmitter Controller : 2VA, Receiver controller : 2VA
Beam focal point 380mm from base of antenna stand
Frequency and transmission power 24GHz approx. Less than 10mW
PAGE TOP